megaco_test_mg and megaco_test_mgc

[Micael Karlberg]

Hi,

On Tuesday, October 7, 2003, at 07:26 PM, Miguel Willigs wrote:

> Hi
> I use the next command line to start the megaco_test_mgc aplication:
> megaco_test_mgc:start(mgc1,{deviceName,"controller6666qq"},{text,tcp},s 
> ilence).
> Is there something wrong in this command?

ET should be a list. And if you intend to run it on the same node, then  
you
can make it:

megaco_test_mgc:start(node(),{deviceName,"controller6666qq"},[{text,tcp} 
],silence).

>
> Thank again

/BMK

>
>> Hi,
>>
>> The start function:
>>
>> 	start(Node, Mid, ET, Verbosity)
>>
>> Node - Is a node name. In the test programs we start slave nodes and
>> run the
>>         MG/MGC in those.
>> Mid  - Is the Mid of the MGC
>> ET   - What encoding type's the MGC shall support
>> 	  basically a list of {encoding_type(),transport_protocol()}
>>         where
>> 		encoding_type() = text | binary
>> 		transport_protocol() = tcp | udp
>> Verbosity - Debugging: silence | info | debug
>> 		   silence - no debug printouts
>> 		   info    - some debug printouts
>>              debug   - lots of debug printouts
>>
>> /BMK
>>
>> On Monday, October 6, 2003, at 08:55 PM, Miguel Willigs wrote:
>>
>>> Thank you for the answer, I have one more question: What are the
>>> parametters in the megaco_test_mgc:start() function?
>>>
>>>
>>>> Hi,
>>>>
>>>> They are not examples. They are part of the megaco test suite.
>>>> No doc. Take a look in the Makefile in the test directory.
>>>>
>>>> /BMK
>>>>
>>>> On Friday, October 3, 2003, at 09:45 PM, Miguel Willigs wrote:
>>>>
>>>>> Hi there.
>>>>>
>>>>> I found two examples files in the erlang instalation:
>>>>> megaco_test_mg.erl
>>>>> and megaco_test_mgc.erl.
>>>>> My question is: How do I run these examples? Is there any
>>>>> documentation
>>>>> about these examples?
>>>>>
>>>>> Thanks in advance
>>>>>
>>>>
>>>
>>
>