megaco_test_mg and megaco_test_mgc

[Miguel Willigs]

Hi
I use the next command line to start the megaco_test_mgc aplication:
megaco_test_mgc:start(mgc1,{deviceName,"controller6666qq"},{text,tcp},silence).
Is there something wrong in this command?

Thank again

> Hi,
>
> The start function:
>
> 	start(Node, Mid, ET, Verbosity)
>
> Node - Is a node name. In the test programs we start slave nodes and
> run the
>         MG/MGC in those.
> Mid  - Is the Mid of the MGC
> ET   - What encoding type's the MGC shall support
> 	  basically a list of {encoding_type(),transport_protocol()}
>         where
> 		encoding_type() = text | binary
> 		transport_protocol() = tcp | udp
> Verbosity - Debugging: silence | info | debug
> 		   silence - no debug printouts
> 		   info    - some debug printouts
>              debug   - lots of debug printouts
>
> /BMK
>
> On Monday, October 6, 2003, at 08:55 PM, Miguel Willigs wrote:
>
>> Thank you for the answer, I have one more question: What are the
>> parametters in the megaco_test_mgc:start() function?
>>
>>
>>> Hi,
>>>
>>> They are not examples. They are part of the megaco test suite.
>>> No doc. Take a look in the Makefile in the test directory.
>>>
>>> /BMK
>>>
>>> On Friday, October 3, 2003, at 09:45 PM, Miguel Willigs wrote:
>>>
>>>> Hi there.
>>>>
>>>> I found two examples files in the erlang instalation:
>>>> megaco_test_mg.erl
>>>> and megaco_test_mgc.erl.
>>>> My question is: How do I run these examples? Is there any
>>>> documentation
>>>> about these examples?
>>>>
>>>> Thanks in advance
>>>>
>>>
>>
>