Which ports does distributed Erlang use?

Chandrashekhar Mullaparthi Chandrashekhar.Mullaparthi@REDACTED
Fri Oct 25 13:53:08 CEST 2002


4369 for epmd and then if you are using R9 you can specify a range of
ports(or a single port) for the individual nodes to listen on as a kernel
config parameter, and open those ports in your firewall.

Chandru

-----Original Message-----
From: Joe Armstrong [mailto:joe@REDACTED]
Sent: 25 October 2002 12:46
To: erlang-questions@REDACTED
Subject: Which ports does distributed Erlang use?



Next Problem,

  At home I'm  sat behind a netgear RT314  natting router which blocks
virtually all incoming requests.

  Which port(s) do I have to  open so that I can get Erlang distribution
working?

/Joe




NOTICE AND DISCLAIMER:
This email (including attachments) is confidential.  If you have received
this email in error please notify the sender immediately and delete this
email from your system without copying or disseminating it or placing any
reliance upon its contents.  We cannot accept liability for any breaches of
confidence arising through use of email.  Any opinions expressed in this
email (including attachments) are those of the author and do not necessarily
reflect our opinions.  We will not accept responsibility for any commitments
made by our employees outside the scope of our business.  We do not warrant
the accuracy or completeness of such information.



More information about the erlang-questions mailing list