Simple Network Management Protocol (SNMP)

Reference Manual

Version 5.9

Table of Contents

snmpa_supervisor

Module

snmpa_supervisor

Module Summary

A supervisor for the SNMP agent Processes

Description

This is the top supervisor for the agent part of the SNMP application. There is always one supervisor at each node with an SNMP agent (master agent or sub-agent).

Exports

start_sub_sup(Opts) -> {ok, pid()} | {error, {already_started, pid()}} | {error, Reason}

Types

Opts = [opt()]
opt() = {db_dir, string()} | ...

Starts a supervisor for the SNMP agent system without a master agent. The supervisor starts all involved SNMP processes, but no agent processes. Sub-agents should be started by calling start_sub_agent/3.

db_dir is mandatory.

See configuration parameters for a description of the options.

start_master_sup(Opts) -> {ok, pid()} | {error, {already_started, pid()}} | {error, Reason}

Types

Opts = [opt()]
opt() = {db_dir, string()} | {config, ConfOpts()} | ...
ConfOpts = [conf_opts()]
conf_opts() = {dir, string()} | ...
Reason = term()

Starts a supervisor for the SNMP agent system. The supervisor starts all involved SNMP processes, including the master agent. Sub-agents should be started by calling start_subagent/3.

db_dir is mandatory.

dir in config is mandatory.

See snmp config for a description of the options.

start_sub_agent(ParentAgent,Subtree,Mibs) -> {ok, pid()} | {error, Reason}

Types

ParentAgent = pid()
SubTree = oid()
Mibs = [MibName]
MibName = [string()]

Starts a sub-agent on the node where the function is called. The snmpa_supervisor must be running.

If the supervisor is not running, the function fails with the reason badarg.

stop_sub_agent(SubAgent) -> ok | no_such_child

Types

SubAgent = pid()

Stops the sub-agent on the node where the function is called. The snmpa_supervisor must be running.

If the supervisor is not running, the function fails with the reason badarg.

Copyright © 1997-2021 Ericsson AB. All Rights Reserved.