streamMode variable

[mwilligs@REDACTED]

Hi
Thaks for the answer.
my problem is the following:

I wana make an 'add' command:

Context=$
{
	Add=A4444
	{
		 Media
		{
		LocalControl{Mode = SendRecv}
		}
	}
}

And this is my code:

where
 CH={megaco_conn_handle,{deviceName,"ctrl"},{deviceName,"mg"}}

 %%%%
addcommand(Pid,CH)->

LCD1=#'LocalControlDescriptor'{streamMode=recvOnly},
SP1=#'StreamParms'{localControlDescriptor=LCD1},
MEDIA1=#'MediaDescriptor'{streams=SP1},
ADD1=#'AmmRequest'{terminationID=[#megaco_term_id{id=?A4444}] ,
descriptors=MEDIA1},
CR1=#'CommandRequest'{command={addReq, ADD1}},
AR=#'ActionRequest'{contextId=?megaco_choose, commandRequests=[CR1]},
megaco:cast(CH, [AR], []).
%%%%%%



what's wrong in this code??

How can I make a test to find errors in my megaco packets?

Thanks again

> Hi,
>
> LCD1=#'LocalControlDescriptor'{streamMode = recvOnly} is the correct.
> What kind of problems did you encounter?
>
> /BMK
>
>
> mwilligs@REDACTED writes:
>  > In the file megaco_message_v1.hlr the structure LocalControlDescriptor
>  > have the streamMode variable.
>  >
>  > Witch are the posible values of streamMode?
>  > In the RFC 3015 page 91 is defined as follow:
>  > StreamMode ::= ENUMERATED
>  > {
>  > 	sendOnly(0),
>  > 	recvOnly(1),
>  > 	sendRecv(2),
>  > 	...
>  > }
>  > The point is: Is it right to write it this way in erlang?:
>  > 	LCD1=#'LocalControlDescriptor'{streamMode=2}
>  > or shall I write it in this way?:
>  > 	LCD1=#'LocalControlDescriptor'{streamMode=recvOnly}
>  >
>  > Because, appareantly neither of this ways is correct.
>  >
>  > thanks in advance
>
> --
> Micael Karlberg          Ericsson AB, Älvsjö Sweden
> Tel:  +46 8 727 5668     EAB/UHK/KD - OTP Product Development
> ECN:  851 5668           Mail: micael.karlberg@REDACTED
> Fax:  +46 8 727 5775
>