![[Ericsson AB]](min_head.gif)
disksup is a process which supervises the available disk
space in the system. It is part of the OS_Mon application, see
os_mon(6). Available for Unix
and Windows.
Periodically checks the disks. For each disk or partition which
uses more than a certain amount of the available space, the alarm
{{disk_almost_full, MountedOn}, []} is set.
Alarms are reported to the SASL alarm handler, see
alarm_handler(3).
To set an alarm, alarm_handler:set_alarm(Alarm) is called
where Alarm is the alarm specified above.
The alarms are cleared automatically when the alarm cause is no longer valid.
The following configuration parameters can be used to change the default values for time interval and threshold:
disk_space_check_interval = int()>0
disk_almost_full_threshold = float()
disk_almost_full
alarm is set. The default is 0.80 (80%).See config(4) for information about how to change the value of configuration parameters.
Types:
DiskData = {Id, KByte, Capacity}
Id = string()
KByte = int()
Capacity = int()
Returns the result of the latest disk check. Id is a
string that identifies the disk or partition. KByte is
the total size of the disk or partition in kbytes.
Capacity is the percentage of disk space used.
The function is asynchronous in the sense that it does not invoke a disk check, but returns the latest available value.
Returns [{"none",0,0}] if disksup is not
available.
Types:
MS = int()
Returns the time interval, in milliseconds, for the periodic disk space check.
set_check_interval(Minutes) -> ok
Types:
Minutes = int()>=1
Changes the time interval, given in minutes, for the periodic disk space check.
The change will take effect after the next disk space check and is non-persistant. That is, in case of a process restart, this value is forgotten and the default value will be used. See Configuration above.
get_almost_full_threshold() -> Percent
Types:
Percent = int()
Returns the threshold, in percent, for disk space utilization.
set_almost_full_threshold(Float) -> ok
Types:
Float = float(), 0=<Float=<1
Changes the threshold, given as a float, for disk space utilization.
The change will take effect during the next disk space check and is non-persistant. That is, in case of a process restart, this value is forgotten and the default value will be used. See Configuration above.