[Ericsson AB]

megaco_encoder

MODULE

megaco_encoder

MODULE SUMMARY

Megaco encoder begaviour.

DESCRIPTION

The following functions should be exported from a megaco_encoder callback module:

EXPORTS

Module:encode_message(EncodingConfig, Version, Message) -> {ok, Bin} | Error

Types:

EncodingConfig = list()
Version = integer()
Message = megaco_message()
Bin = binary()
Error = term()

Encode a megaco message.

Module:decode_message(EncodingConfig, Version, Bin) -> {ok, Message} | Error

Types:

EncodingConfig = list()
Version = integer() | dynamic
Message = megaco_message()
Bin = binary()
Error = term()

Decode a megaco message.

Note that if the Version argument is dynamic, the decoder should try to figure out the actual version from the message itself and then use the proper decoder, e.g. version 1.
If on the other hand the Version argument is an integer, it means that this is the expected version of the message and the decoder for that version should be used.

Module:decode_mini_message(EncodingConfig, Version, Bin) -> {ok, Message} | Error

Types:

EncodingConfig = list()
Version = integer() | dynamic
Message = megaco_message()
Bin = binary()
Error = term()

Perform a minimal decode of a megaco message.

The purpose of this function is to do a minimal decode of Megaco message. A successfull result is a 'MegacoMessage' in which only version and mid has been initiated. This function is used by the megaco_messeger module when the decode_message/3 function failes to figure out the mid (the actual sender) of the message.

Note again that a successfull decode only returns a partially initiated message.

AUTHORS

Micael Karlberg - support@erlang.ericsson.se

megaco 3.4.3
Copyright © 1991-2006 Ericsson AB